Standards Watch is a monthly column by Rex Sanders that examines important backpacking product standards, interviews key people, and describes how the industry uses, abuses, or ignores tests and standards. It also critiques existing standards and marketing, points out missing standards and tests, and proposes other ideas to improve life for backpacking consumers.
Introduction
Steve Seeber has contributed more than a dozen technical papers on testing clothing and fabric performance to the BPL community. In a telephone conversation that lasted almost three hours, we covered a wide range of subjects and filled in many details later by email. In this highly condensed and edited interview, we’ll let Steve do most of the talking about the trials and tribulations of testing and standards development.
![Seeber](https://backpackinglight.com/wp-content/uploads/2020/11/Seeber-728x410.jpg)
Steve: Before I retired, I owned a business that did testing of all sorts of things, electrical, mechanical, and structural. I started the business to do thermal imaging close to 40 years ago. Early on, I started looking at clothing because I thought this could help me select clothes for winter sports. After I retired, I decided that this could make an interesting hobby and possibly lead to some commercial opportunities.
I started with thermal imaging of clothing. Then I started adding other test techniques. I built a device for doing air permeability testing based on a model that I found on Backpacking Light. And I further developed my permeation kettles, as I call them, which I used originally for measuring thermal resistance. But the capabilities of the kettles for making measurements of thermal resistance, moisture vapor transmission (MVTR), wicking and drying of fabrics has advanced to the point that it’s a reliable and repeatable technique.
I also built a device for doing hydrostatic head testing. Then I bought a commercial instrument to replace the DIY device. I modified the commercial instrument so that I could measure pressures of 30,000 millimeters (98.4 ft) [hydraulic head]. I can’t makeGore-Tex leak because you need about 50,000 millimeters (164 ft). But as far as I’m concerned, if you go up to 30,000 millimeters, your fabric is waterproof.
And building all this fit my skills, knowledge, and experience, because it drew on techniques and procedures I had used over my entire career. My testing has been limited to clothing and fabrics rather than camping and backpacking. Although I do spend typically three days per week hiking in the mountains, it’s just day trips. My hikes are anywhere from 8 to 16 miles (13 to 26 km) and 3,000 to 5,000 feet (900 m to 1500 m) elevation gain in the Colorado Rockies. These days, I usually cover more than 30 miles (48 km) per week.
Moisture Vapor Transmission Rate
Steve: MVTR, or Moisture Vapor Transmission Rate, is often called breathability. It’s the ability of the fabric to support the transmission of vapor. As you sweat, that water has to evaporate in order for you to get some cooling out of it. If it’s trapped inside your garment, you’re not going to get any cooling. If you’re in cold conditions, a wicking layer might get moisture away from your skin, but it won’t ultimately get the moisture outside of your outer layer.
For MVTR, I don’t test to any one standard because I can’t afford an environmental chamber –  which is required by most of the standards. My test runs to a vapor pressure differential target. The vapor pressure differential across the garment will drive the moisture through. The permeation kettles maintain the vapor pressure differential regardless of the humidity or temperature conditions in the testing room. My test runs for three hours, and fortunately, it’s automated, so I don’t have to sit and make sure it is doing what it’s supposed to. But it takes a while.
Member Exclusive
A Premium or Unlimited Membership* is required to view the rest of this article.
* A Basic Membership is required to view Member Q&A events
Home › Forums › Standards Watch: Steve Seeber Interview