Topic

Converting Groundsheet into a hoodless poncho


Forum Posting

A Membership is required to post in the forums. Login or become a member to post in the member forums!

Home Forums Gear Forums Make Your Own Gear Converting Groundsheet into a hoodless poncho

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #3632729
    Benjamin K
    BPL Member

    @bkirkland

    I recently picked up a Zpacks Hexamid Solo tent with the solo Groundsheet. I was thinking of converting the Groundsheet into a hoodless poncho and had a few questions.

    once I make the cut, would DCF tape be the best way to cover up the edges?

     

    is a hoodless poncho pointless? I carry an umbrella for head protection and I was thinking this might work pretty well and be multi use since it would work as pack cover, rain cover, and ground cover and I could then ditch my ground cover and rain jacket.

    would the resulting hole then let in too much water  when it is in Groundsheet mode?

     

    has anyone done this or have any thoughts on this idea?

    #3633172
    todd
    BPL Member

    @funnymo

    Locale: SE USA

    1) Headless ponchos definitely are NOT worthless!  Your umbrella will certainly work, and you probably have a hat too, for when the ‘brella is not practical.

    2) Reinforcing w/DCF tape is smart.  Clear packing tape would work, in truth, but will look like crap and lose some effectiveness over time.  Cheap though.

    #3633177
    Rex Sanders
    BPL Member

    @rex

    An umbrella, windshirt, and water-resistant pack works great for me in steady rainfalls. If I expected a lot of blowing rain, I’d consider swapping the umbrella for a poncho plus a rain hat (lighter than any umbrella). I’m not a big fan of poncho hoods.

    A simple slit might not work very well as a head hole. Consider mocking one up in much cheaper polycro or Tyvek before slicing into DCF. If a slit works, you’ll want to reinforce the ends with tape to stop the slice from getting longer.

    would the resulting hole then let in too much water when it is in Groundsheet mode?

    If you camp on wetter ground, or rain channels through your campsite, you’ll regret the head hole.

    Check for pinholes every night and patch them with DCF tape. More holes means more water seeping through.

    Good campsite selection can help with both problems. But sometimes we don’t get to choose an ideal campsite, or conditions change.

    — Rex

     

    #3633253
    Erica R
    BPL Member

    @erica_rcharter-net

    One of the great strengths of DCF is its repairability. If you carry enough tape, you could close the slit in case of a wet campsite.

    My Zpacks poncho/groundsheet has a zipper near the hood. I don’t yet know how waterproof it is. I wrap a bit of cord around the hood to minimize the opening. My plan is to make a lump under the hood in case of a wet night, this’ll maybe keep water away from the hood opening.

    My hood is attached to the rest of the poncho with DCF tape. If you can get some DCF, it might be relatively simple to attach a DCF hood.

    #3633299
    Benjamin K
    BPL Member

    @bkirkland

    thanks for the replies! I’m going to make a cheap one out of polycro and see how that goes before cutting into the DCF.

    my plans for it however are to cut a slit for the head to go through, then attach a small strip of DCF over it that I can snap close with camsnaps. I’ll probably use an old DCF stuff sack for that part.

    #3633325
    Victor Jorgensen
    BPL Member

    @dblhmmck

    Locale: Northern California

    If the DCF stuff sack is large enough for a head opening, maybe you could cut the bottom out of the stuff sack, and tape those bottom edges to the slit in the ground cloth.  It might make a nice turtle neck, but I have not tried this.  I do have an old MLD spinnaker poncho that is hoodless (with about 4 or 5 inches of turtleneck), which is what gave me the idea.

    #3635165
    Rex Sanders
    BPL Member

    @rex

    Stumbled across a similar project:

    YouTube video

    — Rex

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.
Forum Posting

A Membership is required to post in the forums. Login or become a member to post in the member forums!

Get the Newsletter

Get our free Handbook and Receive our weekly newsletter to see what's new at Backpacking Light!

Gear Research & Discovery Tools


Loading...